Pumptec SPRAYER SUB-ASSEMBLY 350U with regulator Manual do Utilizador descarregar pdf (Página 3)

Pumptec, Inc. | 700 McKinley St. NW, Anoka, MN 55303 | 763-433-0303 | www.pumptec.com Version 011614

- The mounting plate should be made of steel or aluminum.

It may be a horizontal or vertical mount plate (for vertical

mounts, the pump must hang below the motor).

- Drill four holes in your mounting plate with a 5/16” drill bit.

The hole pattern is 4 inches wide by 3.3 inches long.

4”

3.3”

4”

3.3”

If mounting vertical, the pump should

be below the motor, as shown.

1 2 3 4 5 6 7 8

Sem comentários

Pumptec SPRAYER SUB-ASSEMBLY 350U with regulator Manual do Utilizador Página 3